Filter
Top Products
If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna,
remove the power inserter and SWM splitter; these will not be used.
Remove the four reflector nuts and bolts, and remove the dish. Set the
nuts and bolts aside.
Disconnect the coaxial cables from the turret. Note that the D port will not
be present on a SWM TRAV’LER antenna.
Remove the bolt holding the cable harness to the unit, and detach the
cable harness from the lift arm.
Set the bolt aside; you will need this later.
Removing the Reflector and LNB Assembly
Reflector nut not shown
1
2
Turret
4
5
Bolt
Cable
clamp
Lift
Arm
Cable
harness
3