Filter
Top Products
-13-
REMOTE CONTROL PREPARATION
Battery Installation
Insert the batteries while observing the positive
(+) and negative (-) polarities as Figure A
Service life of batteries
The batteries normally last for a year although
this depends on the operation and on how
often the remote control is used.
If the remote control unit fails to work even
when it is operated near the player, replace
the batteries with new ones.
Use size AAA UM-4 batteries (2 pieces)
Notes:
Do not use rechargeable (Ni-Cd) batteries
Do not attempt to recharge, short circuit,
disassemble, heat or throw the batteries into
fire
Do not drop, step on the remote control, other-
wise it may damage the parts or lead to mal-
functioning
Do not mix old and new batteries
If the remote control is not going to be used for
a long time, remove the batteries. Otherwise,
electrolyte may leak and lead to malfunctioning
or even burns by electrolyte
Wipe away any electrolyte leaking inside the
remote control, and install new batteries
If the leaking electrolyte has contact with some
parts of your body, wash it off thoroughly with
water.
Remote control operation range
The operation range of the remote control is
no more than 5m from and within about 60
degree of the front of the unit.(Figure B)
The operating distance may vary according to
the brightness of the room
Note:
Do not point bright lights to the remote control
sensor
Do not place objects between the remote con-
trol and the remote control sensor
Do not use this remote control together with
the remote control of any other equipment.
PDVDX100S-100B-im.p65 06-5-16, 11:3113