Filter
Top Products
i Mai
i
Exit
Test signal
Rear iiSubwoofer i
(L)@(L)@@ (R)@(R)@!i @ @ i
@ [...... 1
Center speaker
Difference
Approx. 50 cm (1 1/2 feet)
Approx. 100 cm (3 feet)
Approx. 150 cm (5 feet)
Approx. 200 cm (6 feet)
Setting
1.3 ms
2.6 ms
3.9 ms
5.3 ms
• Rear speakers
Difference Setting
Approx. 200 cm (6 feet) 5.3 ms
Approx. 400 cm (12 feet) 10.6 ms
Approx. 600 cm (18 feet) 15.9 ms
• Output mode @
Change the settings of each speaker in accordance with your speaker system.
_11 Press the cursor buttons (<, c_,A,V) to select a speaker and press
ENTER.
[] Press the cursor buttons (A,V) to select the setting and press
ENTER.
Example: Left surround (rear) speaker
@ when the speaker is not used
@ when using a large speaker capable of low-frequency (under 100 Hz)
output.
@ when using a small speaker that is not capable of low-frequency output.
The L and R (left and right main speakers) settings are automatically decided by
the SW (subwoofer) setting.
• Delay time @
To obtain the maximum effect of Dolby Digital 5.1 channel source, all speakers
should be located at the same distance from the listening position. However, in
many cases they are not the center speaker is placed in line with the main
speakers, etc. You can virtually increase the distance of the center and rear
speakers by adjusting the delay time.
[] Press the cursor buttons (% c_, A,V) to select a 'ms' box and
press ENTER.
[] Press the cursor buttons (A,V) to adjust the delay time and press
ENTER.
• Speaker balance @
You can adjust the output level of each effect speakers (center, surround L_)
using the test tone.
[] Press the cursor buttons (<, c_, A,V) to select 'Test' and press
ENTER.
The test tone is one speaker at a time in below order, starting with the left
main speaker.
L _C _R _ RS _ LS
I
[] Listening to the test tone, press the cursor buttons (A,V) to adjust
the volume of effect speakers and press ENTER.
The value in the 'dB' box changes.
The subwoofer cannot output the test tone. Play something and retum to this screen to adjust
the output level of the subwoofer.
• To exit the speaker setting mode
Press the cursor buttons (<_,E>,A,V) to select 'EXIT' and press ENTER.
• These adjustments are not effective on digital signal output from this unit. Make
adjustments at your amplifier.
• These adjustments may not be effective when the disc's original sound design is protected.
PPCM indicator lights up or DMIX indicator turns off in that case.
29