Filter
Top Products
IiloIq'l_-'Flil,l,llli'l_
PROBLEM
No sound when playing
a disc encoded with
DTS.
No sound from some
speakers.
Sound distorted.
Sound 'skips'.
Sound 'hums'.
Noise from a nearby
tuner.
Noise from inside of
the unit.
The remote control
does not work.
Audio track and/or
subtitle language is not
the selected one.
No subtitles.
Angle cannot be
changed.
The password for
setting parental level
has been forgotten.
POSSIBLE CAUSE
Incorrect setting(s) at the audio section of
'Setup menu' on this unit or at 'input mode'
on your amplifier.
With some DVD-Audio, output channels are
specified by the disc.
Incorrect 'Speaker settings'. (when 6CH
DISCRETE outputs are connected to your
amplifier)
Audio output form this unit becomes two
channels when the virtual surround feature is
on.
Virtual surround effect is emphasized too
much.
This unit is being subjected to vibrations or
impacts.
The disc is dirty.
Incorrect cable connections.
The tuner is too close to the unit.
The disc maybe warped.
The batteries are weak.
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The disc does not contain the language you
have selected.
The disc does not have subtitles.
Subtitle is turned off.
The disc or the scene being played does not
support multi-angle.
WHAT TO DO
Select proper settings.
Change the settings to suit your speaker
system.
Turn virtual surround mode off.
Turn virtual surround mode off.
Relocate the unit.
Clean the disc.
Securely connect the audio cables. If the
problem persists, the cables may be defective.
Place the tuner and the unit farther apart.
Replace the disc.
Replace all batteries with new ones.
Relocate the unit.
Show subtitles by pressing SUBTITLE or
using on-screen menu.
Clear all settings on the setup menu. See
'Returning setup menu to the factory-setting'
below this table.
Refer to
Page
26, 27
29
23
23
3
8
7
7
16
• Returning setup menu to the factory-setting
While playback is stopped, press and hold 00 (PAUSE), and then DISC SKIP and PLAYXCHANGE on the front panel until
'Initialized' appears on the video monitor. All settings on the setup menu return to the factory settings.
31