Filter
Top Products
PAGE 12
206-3489-O
Auto Program (Channel Search)
1
2
3
4
5
6
7
TIMER
CHPREVIEW
ENTER
1
2
3
4
5
6
7
8
9
0
POWER
FLSHBK
MUTE
VOL
UME
CHANNEL
TV/FM
CC
MENU
BANK
ADJ
ADJ
SELECT
3/5
4/6
1
7
2
Use Auto Program to specify Antenna or cable service
incoming signal source and automatically store all of the
channels that are found by channel search
With the Installer remote control in hand, press the
POWER key to turn on the TV.
Press MENU repeatedly so the Setup menu appears.
Using SELECT on the remote control, highlight Auto
Program on the screen.
Press a Right or Left ADJ (Adjust) arrow to reach the
Auto Program screen.
Using SELECT, choose either Cable TV or Off-Air Antenna
on your screen. (The flashing option is selected.)
Press a Right or Left ADJ arrow to begin the Channel
Search.
Press ENTER when finished.
Mini glossary
OFF-AIR-ANTENNA If the guest can only view over-the-air broadcasts, select Antenna.
CABLE If you provide cable service to your guests, select Cable.
Note: Auto Program finds channels being received by the TV
tuner.
Cable will not work unless the lodge provides a cable service.
(If the Auto Program line appears in red, then it did not pass
one of the internal tests. To set Auto Program to white, set the
upper nibble of the EEPROM location $1FFh to $B0h.)