Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
206-3489-O
PAGE 7
Hook Up Your Antenna to the TV
300 TO 75 OHM
ADAPTER
ANTENNA
CABLE
M.P.I.
TV back
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV back panel
(expanded view)
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
TV back
TV back panel
(expanded view)
ANTENNA
CABLE
M.P.I.
RF coaxial wire
(75ohm)
Antenna
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
back of
remote
120 V AC
60 Hz
1
2
3
4
5
Connect an off-air antenna to the TV
If you have a 75 ohm RF cable, then you don’t need
any adapters!
A 300 to 75 ohm adapter is not included with the
Zenith TV.
Locate the Antenna/Cable jack on the back of the TV.
Connect the cable that runs from the wall directly to
this jack, according to the diagram to the right.
Remove the back of the remote and put in two AA bat-
teries.
Plug in the TV. Do not plug it into a switched outlet.
The TV is designed to operate on standard current, 120-
volt 60 Hertz AC. Do not attempt to operate it on DC
Current.
Go to page 12 to Auto Program the TV.