Filter
Top Products
206-3489-O
PAGE 8
Hook Up Your Cable (CATV) to the TV
If you’re using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you’re using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don’t worry, that’s all
you need!
Cable TV
wall jack
RF coaxial wire (75ohm)
TV back
ANTENNA
CABLE
M.P.I.
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
ANTENNA
CABLE
M.P.I.
Cable TV
wall jack
Cable box
In
Out
RF coaxial wire (75ohm)
3 4
output
switch
TV back
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
Locate the Antenna/Cable jack on the back of
the TV.
Connect the cable that runs from the wall
directly to this jack, according to the diagram
to the right.
Remove the back of the remote and put in two
AA batteries.
Plug in the TV. Do not plug it into a switched
outlet. The TV is designed to operate on
household current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC Current.
Go to page 12 to Auto Program the TV.
back of
remote
120 V AC
60 Hz
1
2
3
4
5
Connect cable service to the TV