Filter
Top Products
206-3489-O
PAGE 9
Hook Up Antenna and VCR to the TV
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
In
Out
Audio
Video
3 4
VCR back
VCR back AV panel
output
switch
ANTENNA
CABLE
M.P.I.
TV back panel
(expanded view)
A/V cables
not included
with TV
TV back
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
TV back
RF coaxial wire
(75ohm)
not included
with TV
RF coaxial wire
(75ohm)
Antenna
A/V cables
not included
with TV
R- AUDIO- L
VIDEO
IN
MATRIX
OUT
IN
In
Out
Audio
Video
3 4
VCR back
VCR back AV panel
output
switch
ANTENNA
CABLE
M.P.I.
TV back panel
(expanded view)
TV back
back of
remote
120 V AC
60 Hz
1
2
3
4
5
Connect an off-air antenna and VCR to the TV
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play videocas-
settes in stereo sound.
Locate the Antenna/Cable jack on the back of the VCR.
Connect the cable that runs from the antenna directly to
this jack, according to the diagram to the right. As
required, make the other connections as shown to the
right.
Remove the back of the remote, put in two AA batteries.
Plug in the TV. Do not plug it into a switched outlet. The
TV is designed to operate on standard current, 120-volt
60 Hertz AC. Do not attempt to operate it on DC Current.
Go to page 12 to Auto Program the TV.