Filter
Top Products
PAGE 34
206-3489-O
A slow flashing green light indicates there is a problem with the communications between the TV and the programmer. In this
case, check for a damaged cable, poor contacts, or other connection troubles.
If the status indicator is red, the programmer batteries are low and should be replaced. Use 4 good quality alkaline AA batteries.
1
2
3
LT1500 QuickSet Programmer
Use the LT1500 QuickSet Programmer to duplicate the TVs setup
1
2
3
4
5
The optional QuickSet II Programmer (LT1500) allows custom setup and programming
information to be quickly copied from a master TV into multiple television sets. Once
learned from the master, setup data is retained in the LT1500 for future use and recall.
When using the LT1500, operation will be easier if the TV set is connected to a good
quality signal and operating with a stable picture displayed. To operate the LT1500, use
the indicated keys on an HP602, LP702, or MBR3447 remote, or the front panel keys on
the TV receiver.
Set up a master TV set using your remote and following the instructions in this operating guide. Set all features you wish to
customize including the channel scan list, channel labels, and service menu setups.
Connect the LT1500 to the master TV set using the cable provided with the programmer. Connect the cable between the MPI
jack on the TV and the programmer. Connecting the programmer to the TV set automatically activates the programmer power-
switching circuits.
Once connected, check the “Status Indicator” LED on the programmer. The indicator should be flashing a green double-blink
“heartbeat” pattern.
If communications are good, the sign-on screen will be displayed on the TV screen as shown on the quick setup instructions
which accompany the LT1500. If you intend to set the TV or programmer real-time clocks, note the clone clock and TV clock
time settings, then press a key to proceed to the main clone menu.
If you have previously stored a TV setup in a particular clone memory, it may be changed if desired by overwriting it with a
new setup. There is no need for a separate memory clear operation.
Item 1: Learn From TV
Setups stored in programmer memory are nonvolatile and will be retained even after a battery change.
Press (1) then ON/OFF, POWER, or ENTER to begin the learning process. Alternatively, use the TV front panel CHANNEL UP or
CHANNEL DOWN keys to highlight your choice, then press ON/OFF, POWER, or ENTER to activate.
The next screen will allow you to choose which of the available memories will be used to store this TV setup. With four memo-
ries available, four different TV setups can be stored in the LT1500.
Using the on screen menu, choose a memory or choose to return to the main selection menu, then press ON/OFF, POWER, or
ENTER to activate the selection.
The next screen gives you one last opportunity to check the versions of TV and clone setups. Press ON/OFF, or POWER to acti-
vate the learning cycle or any other key to return to the selection menu to make other choices.
Once the process has begun, the TV screen will display the ”LEARNING IN PROGRESS” message. Please wait until the process is
completed. When the TV screen displays “LEARNING COMPLETED”, press any key to end the learning process and return to the
clone selection menu.