PDS • User’s Guide 63
4. Operation
Setup Menu
ea`m
The HDCP Submenu, shown in the following illustration, lets you set HDCP capability for
inputs. For an introduction to HDCP, see “A Word About HDCP” on page 5.
The HDCP setting is either ON or OFF. You can set this capability for the following inputs
and outputs:
• In 5 (DVI-I) — The default setting is OFF.
• In 6 (DVI-I) — The default setting is OFF.
• In 7 (DVI-I) — The default setting is OFF.
• In 8 (DVI-I) — The default setting is OFF.
To turn HDCP capability on or off, use the following procedure:
1. On the Setup Menu, select User Preference.
2. On the User Preference, select HDCP. The HDCP Submenu appears.
3. Select an input or output and turn the ADJUST knob once. Then press SEL.
^ìíç=q~âÉ
The Auto Take mode allows you to bring an input source to Program by simply pressing an
input button (1 through 8, SDI, or LOGO), and without requiring a Take.
Regardless of your Auto Acquire settings, the input button you select blinks slow, to
indicate that the system is performing an action such as an auto acquire, file association, or
another action. When the system completes its tasks for the input, the button lights solid
and the source goes to Program automatically.
• When ON, Auto Take overrides user preferences for Black Auto Take. The value
for this menu item is bracketed.
• When OFF, the selected input button blinks slow. Press TAKE to perform the
transition.
_ä~Åâ=^ìíç=q~âÉ
The Black Auto Take function controls the behavior of the BLACK button:
• When ON, the BLACK button transitions the Program output to/from black, as
soon as the button is pushed.
• When OFF, the BLACK button blinks when pressed, to indicate “pending.” Press
TAKE to perform a transition to/from black.
Refer to the “Using Black” section on page 83 for details.
HDCP
> In 5 (DVI-I) Off
In 6(DVI-I) On
In 7(DVI-I) Off
In 8(DVI-I) Off
Note
In 7 and In 8 are not available for selection in PDS-701 units.
