SPARC Enterprise M4000/M5000 Servers Product Notes 13
Software Issues
This section describes software specific issues and workarounds.
XCP Issues and Workarounds
TABLE 5 lists known XCP issues and possible workarounds.
TABLE 5 XCP Issues and Workarounds
ID Description Workaround
RTIF1-
070418-004
All domains must be powered off before
upgrading the XCP firmware.
Power off domains before using the
flashupdate(8) command to upgrade XCP
firmware.
RTIF1-
070418-005
If you log in to the XSCF while it is still
booting, you may get a bash$ prompt instead
of the XSCF> prompt, and be unable to
perform most operations.
Log out of the bash$ prompt and wait for the
XSCF to finish booting.
RTIF1-
070418-009
While XSCF is running, error message of
"OOM kill" might be displayed to XSCF
console, and process may go down and/or
watchdog timeout may occur and XSCF may
reboot.
Check that XSCF is started. If not started, use
the rebootxscf(8) command to restart XSCF,
or stop all the domains and then execute the
system power off/on (AC OFF/ON).
RTIF1-
070418-010
The showdomainstatus -a command shows
domain status as Powered Off, but the
showboards -a command shows the domain
is testing.
Use the showboards command to check the
status of domain power.
The showdomainstatus command takes a
longer time to show the correct status.
RTIF1-
070418-011
Some commands that update configuration
data take a relatively long time to execute.
Do not cancel set* commands. They appear to
hang, but eventually complete in about 30
seconds.
RTIF1-
070418-012
The fault (memory.block.ue) is encountered
and reported periodically.
An uncorrectable error exists in a DIMM and
the DIMM should be replaced.
RTIF1-
070418-020
When using the XSCF Web to import a
firmware image, if the image is corrupted, the
flashupdate command might later report an
internal error.
Import again a firmware image. Reboot the
XSCF Unit, then use the flashupdate
command again to clear the internal error.
