SPARC Enterprise M4000/M5000 Servers Product Notes 21
6527811 showhardconf(8) on XSCF can not display
PCI card information that is installed in
External I/O Expansion Unit, if the External
I/O Expansion Unit is configured using PCI
hotplug.
No workaround is available at this time.
In case of each PCI card in the External I/O
Expansion Unit is configured using PCI
hotplug, the PCI card information is displayed
correctly.
6529479 ereport.io.ddi.fm-capability error messages
may be logged in ereport during system
reboot.
None available at this time. Ignore the
messages.
6529714 Warning messages occur while trying to
configure more than four X4447A-Z or
X1027A-Z1 cards into one I/O Boat.
No workaround available at this time.
6530178 DR addboard(8) command can hang. Once
problem is observed, further DR operations are
blocked. Recovery requires reboot of the
domain.
There is no workaround. Check availability of
a patch for this bug.
6530288 Ap_Id format may not be shown correctly by
cfgadm(1M) command.
None available at this time.
6530753 Some of the PCI slots in the External I/O
Expansion Unit PCI slots are not displayed
during a normal boot operation.
Use one of the following operations to display
all of the PCI slots.
• boot -r (at open boot prompt)
• devfsadm -C (at Solaris prompt)
• cfgadm (twice at Solaris prompt)
6531036 The error message network
initialization failed appears
repeatedly after a boot net installation.
There is no workaround.
6531668 System hangs when executing parallel hot
plug operation with SP DR in suspend phase.
No workaround available at this time.
6532215 volfs or dscp service may fail when domain is
booted.
svc:/platform/sun4u/dscp:default:
Method "/lib/svc/method/svc-dscp
start" failed with exit status 95.
svc:/system/filesystem/volfs:defaul
t: Method or service exit timed
out. Killing contract 59.
Restart the service if the failure is observed. To
avoid the problem, issue the following
commands.
# svccfg -s dscp setprop
start/timeout_seconds=count: 300
# svccfg -s volfs setprop
start/timeout_seconds=count: 300
# svcadm refresh dscp
# svcadm refresh volfs
TABLE 6 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround
