20 SPARC Enterprise M4000/M5000 Servers Product Notes for XCP Version 1041 • October 2007
6515648 "Replumb Failed" error appears when
dr@0:SB1::memory fails.
Once the DR operation is complete, it can be
plumbed up manually.
Example steps to re-plumb the interface
manually:
# ifconfig interface plumb xxx.xxx.xxx.xxx
netmask + broadcast + up
# ifconfig interface group group-name
# ifconfig interface addif xxx.xxx.xxx.xxx
-failover deprecated up
This workaround assumes that the
/etc/hostname.interface file is correctly
configured for the IPMP group and does not
need any modification. The IP addresses used
in the example above should match what was
previously used and what matches the
/etc/hostname.<interface> file.
6516135 Ap_Id format and devices may not be shown
correctly by cfgadm(1M).
Use the following operations to display all of
the PCI slots.
1) devfsadm (at Solaris prompt)
2) cfgadm
6519290 Large amounts of I/O on swap devices can
cause the system to appear hung by over
welling the I/O system. The amount of I/O
required can be generated through a number
of ways, eg memory shortage, heavy use of
/tmp etc.
Set the following to /etc/system and then
reboot the domain:
set maxfastscan=0x2000
6520990 Domain may cause a panic when
deleteboard(8) command for kernel board
by using Dynamic Reconfiguration (DR).
To mask this error, add the following entry to
the /etc/system file.
set drmach:fmem_timeout = 30
6522017 DR and ZFS may not be used in the same
domain.
Set the maximum size of the ZFS ARC lower.
6522433 After the CPU hardware error occurred, the
fmdump(1M) command on the domain may
display an incorrect faulty component.
Check system status on XSCF.
6525010 PCIe correctable errors can be recorded in the
FMA error log.
Add the following entry to /etc/system to
prevent the problem:
set pcie:pcie_aer_ce_mask = 0x2001
TABLE 6 Specific Issues and Workarounds Concerning Solaris (Continued)
CR ID Description Workaround
