A SERVICE OF

logo

49
Basic Installation
Wall or Rack Mounting
The SX-200 ICP controller is wall and rack mountable. The NSU is
rack-mountable only.
Wall mounting the controller
When mounting the controller on a wall, use the supplied long bracket and
small bracket and the supplied screws (#10).
.
1. Turn the controller upside down.
2. Locate the two holes on the bottom of the Controller as shown in the
following figure.
3. Remove the two feet as shown below.
CAUTION:Make sure the wall material is capable of supporting
the weight of the unit. Mitel is not responsible for units
damaged as a result of improper wall mounting.