A SERVICE OF

logo

51
Basic Installation
6. Screw the supplied small bracket onto the bottom of the controller as
shown.
7. Mount the bracket onto the wall.
a. Pre-drill two pilot holes into two wall studs with 16" centers.
b. Orient the bracket over the two holes as shown below.
c. Insert a screw into the hole on the left side of the bracket.
d. Insert a screw into the hole on the slot on the right side of the
bracket.
8. Hang the controller onto the mounted bracket as shown below.
Position it with the front panel facing to one side so that the ports and
connectors are accessible.