→ Dialing Mode
→ DTMF Width
→ Pulse Speed
3.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
→
CO Dial Mode
→ DTMF Width
→ CO Pulse Speed
PT Programming Manual References
[410] LCOT Dialing Mode
[411] LCOT Pulse Rate
[412] LCOT DTMF Minimum Duration
4.1.3 Dial Tone
Description
The following dial tones inform extension users about features activated on their extensions:
Each dial tone type has two frequencies, such as dial tone 1A and dial tone 1B.
Type Description
Tone 1A/1B A normal dial tone is heard when:
a. No features listed for dial tones 2 through 4 has been set, or
b. Automatic Route Selection (ARS) is used.
Tone 2A/2B This tone is heard when:
• There are messages that have previously been listened to and no new
messages on the SVM card.
*1
• Any of the features below are set.
• Absent Message
• BGM
• Call Forwarding (FWD)
• Call Pickup Deny
• Call Waiting
• Do Not Disturb (DND)
• Extension Dial Lock
• Executive Busy Override Deny
• Hot Line
• Timed Reminder
Tone 3A/3B This tone is heard when:
• A called PS is being searched for.
• The
recording time used by the Simplified Voice Message (SVM) feature
reaches the limit.
*1
• Any of the features below are performed.
• Account Code Entry
• Consultation Hold
• Answering a Timed Reminder call with no message
Document Version 2008-11 Feature Manual 69
4.1.3 Dial Tone
