G7 ASD Operation Manual 47
Program Mode
Table 6 lists the menu items of the Program mode and maps the flow of the menu selections. The
Parameter Numbers for the listed functions are provided where applicable. The functions listed may be
accessed (and changed) as mapped below or via the Direct Access method: Program ⇒ Direct Access ⇒
Applicable Parameter Number.
Table 6. Program mode mapping.
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
FUNDAMENTAL
PARAMETERS
Frequency Setting
Maximum Frequency F011
Upper Limit F012
Lower Limit F013
V/f Pattern F015
Standard Mode Selection
Command Mode F003
Frequency Mode #1 F004
Frequency Mode #2 F207
Reference Priority Selection F200
Mode #1/#2 Switching Frequency F208
Accel/Decel #1 Settings
Accel #1 F009
Decel #1 F010
Accel/Decel Pattern F502
Automatic Accel/Decel Enable/Disable F000
Motor Set #1
#1 Base Frequency F014
#1 Max Output Voltage F306
#1 Torque Boost F016
#1 Electronic Thermal Protection Level F600
STARTUP WIZARD
(See the section titled Startup Wizard Requirements on pg. 40.) N/A
CHANGED FROM
DEFAULT
(See the section titled Default Setting Changes on pg. 39.) N/A
DIRECT ACCESS
(See the section titled Direct Access Parameter Information on pg. 59.) N/A
EOI OPTION SETUPS
Contrast (adjustment)
Darker (highlight Darker and press Enter) N/A
Lighter (highlight Lighter and press Enter) N/A
Local/Remote Key
Command N/A
Frequency N/A
Realtime Clock Setup
Date and time setting (requires RTC option) N/A
Preferences
Double Click Speed N/A
Arrow Speed N/A
Encoder Speed N/A
Encoder Action N/A
Alarm Popups
Overheat Alarm N/A
Undervoltage Alarm N/A
