Broadband VPN Gateway User Guide
3. In the Address box, enter "HTTP://" and the IP Address of the Broadband VPN Gateway, as in this example, which uses the
Broadband VPN Gateway 's default IP Address:
HTTP://192.168.0.1
If you can't connect
If the Broadband VPN Gateway does not respond, check the following:
• The Broadband VPN Gateway is properly installed, LAN connection is OK,
and it is powered ON. You can test the connection by using the "Ping" com-
mand:
• Open the MS-DOS window or command prompt window.
• Enter the command:
ping 192.168.0.1
If no response is received, either the connection is not working, or your
PC's IP address is not compatible with the Broadband VPN Gateway 's IP
Address. (See next item.)
• If your PC is using a fixed IP Address, its IP Address must be within the range
192.168.0.2 to 192.168.0.254 to be compatible with the Broadband VPN Ga-
teway 's default IP Address of 192.168.0.1. Also, the Network Mask must be
set to 255.255.255.0. See Chapter 4 - PC Configuration for details on check-
ing your PC's TCP/IP settings.
• Ensure that your PC and the Broadband VPN Gateway are on the same net-
work segment. (If you don't have a router, this must be the case.)
4. You will be prompted for a username and password, as shown below.
Figure 5: Password Dialog
• Enter admin for the User Name, and password for the Password.
• These are the default values. Both the name and password can (and should) be changed, using the Admin Login screen. Once you
have changed either the name or the password, you must use the current values.
10
