Filter
Top Products
22 CONFIGURING YOUR OFFICECONNECT NETBUILDER 10 BRIDGE/ROUTER
c Click Apply.
10 Add a default route to port 4 to tell the OfficeConnect
NETBuilder bridge/router which port to use to
communicate to the internet
a In the Basic IP section of the navigation frame, click IP
Route.
b In the ROUte field, enter the route:
0.0.0.0 !4 1
c Click Apply.
11 In the Policy Management Network Address Translation
section on the navigation frame, click the NAT
IPCPAddressMap link.
a In the start field, choose 4.
b In the IPCPAddressMap field, enter Enable.
c Click Apply.
12 In the Policy Management Network Address Translation
section on the navigation frame, click the NAT CONTrol
link.
a In the start field, choose 4.
b In the control field, choose Enable.
c Click Apply.
13 In the Dial on Demand ISDN Setup section of the
navigation frame, click the PATH CONTrol link.
a In the start field, choose 3.
b In the CONTrol field, choose Enabled.
c Click Apply.
14 Enable IP routing.
a In the Basic IP section of the navigation frame, click the
IP CONTrol link.
b In the CONTrol field, choose ROute.
c Click Apply.
OC10.book Page 22 Thursday, May 13, 1999 2:33 PM