Filter
Top Products
Configuration Procedure 23
Configuring IPX Network Addressing
Use this procedure when you use IPX as your network
protocol. If you use IP as your network protocol, go to
“Configuring IP Network Addressing” on page 20.
To configure IPX network addressing, follow these steps:
1 Return to the Web Link home page, click Web Link in the
banner.
2 In the Web Link navigation frame, click the Configuration
link.
3 In the Step-by-Step Configuration section of the navigation
frame, click the IPX Routing link.
4 Specify an IPX network number and header format.
a In the Basic IPX section on the navigation frame, click
the IPX NETnumber link.
b In the start field, choose 1.
c In the NETnumber field, enter the IPX network number
for the Ethernet LAN. For example, enter:
&AAA eth
d Click Apply.
e In the start field, choose 4.
f In the NETnumber field, enter the IPX network number
for the WAN interface. For example, enter
&CCC ppp
g Click Apply.
5 Enable IPX Routing.
a In the Basic IPX section of the navigation frame, click the
IPX CONTrol link.
b In the start field, choose 1.
c In the CONTrol field, choose ROute.
d Click Apply.
e In the start field, choose 4.
OC10.book Page 23 Thursday, May 13, 1999 2:33 PM