Filter
Top Products
When the menu screen is displayed
The menu screen may be displayed first after
loading a DVD or video CD 2.0 with PBC ON
which contains a menu.
You cannot select the program in the menu
screen while the on screen display appears.
Turn off the on screen display before playing a
disc. See page 15.
DVD: Use ikjl or the number buttons
to select the program you would like to view,
then press ENTER to begin playback. Press
TOP MENU or MENU to return to the menu
screen.
Video CD: Use the number buttons to
select the program you would like to view.
Playback begins. Press RETURN to return
to the menu screen.
When PBC is set to ON, you cannot select
the program with the main unit.
For either DVD or Video CDs, menu
continuations and the exact operating
procedures for using the menu may vary from
disc to disc. Follow the instructions on the
menu screen.
To turn the power off
Slide the POWER switch on the main unit toward
OFF, or press POWER on the remote control.
To avoid the accidental operation
Slide the POWER switch to HOLD.
After playing back a disc
Slide the POWER switch toward OFF to turn
the power off.
If stop mode or pause mode lasts for more
than 5 minutes, the unit automatically enters
standby mode (Auto power saving).
While the liquid crystal display is off, the
power indicator remains lit. Press c(Play) to
turn on the power again.
Close the disc cover.
This unit automatically begin playing the
disc.
If the disc does not begin to play, press
c(Play).
5
When the remote control is used
The instructions in this manual refer mainly to
the buttons on the main unit. Buttons on the
remote control with the same names as
those on the main unit can be used as well.
Playing back (continued)
11
ENGLISH
NOTES
• Load only one disc.
• After loading or removing a disc, make sure to
close the disc cover. If the inside the unit
becomes dusty, it will cause a malfunction.
• When playing a DVD disc, set the PAL/NTSC
switch on the right side to suit the color system
of the disc playing during stop or power off.
Otherwise, the full potential of the disc may not
be realized.