Filter
Top Products
14
ENGLISH
Connections (continued)
Connecting to audio equipment
Audio equipment to be connected
to the unit
None (only a TV is connected)
•Amplifier
• Stereo system
• Dolby Digital decoder
•AV receiver equipped with a Dolby Digital or
Dolby Pro Logic decoder
• DTS decoder
•AV receiver equipped with a DTS decoder
Refer to
A on pages 15-17
B on page 18
C on page 19
D on page 20
E on page 21
Notes on digital audio connections
•When using an optical connection, remove the dust cap
from the DIGITAL OUT OPTICAL jack on the rear of the
unit. Keep the cap handy. When not using the optical
connection, the dust cap should be replaced.
• Use either a commercially available optical cord or a 75-
ohm coaxial cord when connecting the unit to an AV
amplifier with a digital input jack. The supplied video cord
can also be used instead of a coaxial cord.
CAUTION
DO NOT select "DOLBY DIGITAL/PCM" or "Stream/PCM"
for the "Digital Audio Output" in the setup menu when
connecting to an AV receiver not equipped with a Dolby
Digital decoder or DTS decoder (with an optical or coaxial
connecting cord).
Merely attempting to play a disc may cause a screeching
noise which could be harmful to your ears and damage
the speakers. In this case, be sure to select "PCM" for the
"Digital Audio Output".
Note on DTS-encoded discs
Set "Digital Audio Output" to "Stream/PCM" in the setup
menu, after connecting the digital output of this unit to an
AV receiver equipped with a DTS decoder.
Input jack of the audio
equipment
—
Digital input jack
Analog audio input jacks (L/R)
Digital input jack
Digital input jack
Analog audio input jacks (L/R) F on page 22