Filter
Top Products
41
5 Using the Geometric Menu
Option Press /
Description
Contrast 0~100 Reduce/Enhance
Brightness 0~100 Darken/Brighten
Back Light Middle, Bright, Dark Adjust the balance of back light
Auto Setting
To adjust the position of
display automatically
Phase 0~31 Soften/Sharpen
Manual Clock 0~255 Decrease/Increase
Display
Adjustment
Vertical position,
Horizontal position
To adjust the position of
display
Note:
If your current input source is “VGA” or “DVI”, push “MENU” enter into this menu. It
is not available in other input source mode.
“Auto Setting”, “Phase”, “Manual Clock” and “Display Adjustment” item can be adjust
when input source is “VGA”.
■ Selecting Channel
Press CH+/- on the remote control to search the channels, the channel number will
increase or decrease by 1 for each pressing excluding the skipped channels.
Press number buttons 0~9 to select the corresponding channel content. If the
channel number is bigger than 9, just press the two number buttons successively. If
the channel number is bigger than 100, just press the three number buttons
successively. The time interval should not exceed 2 seconds.
If the channel number you pressed is bigger than the maximum channel number that
the setting is permitted, the maximum numbered channel content will be remained.
■ Channel Preview
Press RECALL button to switch between present channel and previous channel.
(Only for TV)
(Continued on next page)