Alpine DVA-9861 DVD Player User Manual


 
15-EN
01GB05DVA9861.fm
ALPINE DVA-9861 68-04123Z61-A (EN)
In this section, both remote control and main unit operation are
described.
DVD/Video CD operations can be performed from both the remote
control and the main unit. In this section, both remote control and
main unit operations are described.
To view DVD/Video CD, the optional TV monitor is required.
DVA-9861 automatically changes the video output signal (NTSC or
PAL), according to the disc. To set NTSC or PAL on the connected
monitor, refer to the Owner's Manual of the monitor.
Disc types that can be used for each heading are
represented by the following marks.
Playing a Disc
Play Position Memory Function
Even if you turn power off or switch the Ignition Key to OFF during
playback or change the source, playback will continue from the point
where playback stopped when the power is turned ON again.
1
Press (OPEN).
The front panel will open.
2
Insert a disc with the label side facing up.
The disc will be pulled into the unit automatically.
Close the front panel manually.
When a disc is already inserted, press SOURCE/POWER
on the main unit to switch to the DISC mode.
TUNER XM RADIO/SIRIUS*
1
DISC IPOD*
2
CHANGER*
3
TUNER
*
1
Only when XM Radio or Sirius Radio is connected.
*
2
Only when the iPod is connected.
*
3
Only when the CD changer is connected.
3
To eject the disc, press after pressing (OPEN)
to open the front panel.
Do not remove a disc during its eject cycle. Do not load more than
one disc at a time. A malfunction may result from doing either.
If the disc does not eject, press and hold for at least 2 seconds.
The reverse side of a double-sided DVD will not be played
automatically. Remove the disc, turn it over, and reinsert it.
Never insert map discs for navigation purposes as they could damage
the equipment.
Refer also to “DVD Setup” (pages 26 to 28).
DVD/Video CD
4
RETURN
MENU
CLR
DISP./TOP M.
AUDIO
Numeric
keypad
(0 to 9)
ANGLE
SUBTITLE
/
ENT.
SOURCE/
POWER
(OPEN)
UPDN
/
DVD Commercial Video discs (used for the
distribution of movies, etc.) or a DVD-R/DVD-
RW/DVD+R/DVD+RW recorded in a video
mode can be used.
DVD Commercial Audio discs can be used.
DVD-R/DVD-RW discs recorded in DVD-VR
mode can be used.
Video CD discs can be used.
Caution
Not all functions will operate for every DVD. See the individual
DVD’s instructions for details on the features supported.
Fingerprints on a disc may adversely affect playback. If a
problem occurs, remove the disc and check for fingerprints on the
playback side. Clean the disc if necessary.
When using the remote control, be careful to press only one
button at a time. Pressing multiple buttons at the same time may
cause erroneous operation.
If you try to perform an invalid operation (based on the type of
disc being played), the following mark is displayed on the
monitor screen:
01GB00DVA9861.book Page 15 Tuesday, December 6, 2005 3:41 PM