Alpine DVA-9861 DVD Player User Manual


 
26-EN
01GB05DVA9861.fm
ALPINE DVA-9861 68-04123Z61-A (EN)
Connecting to an External Amplifier
When an external amplifier is connected, sound quality can be improved
by stopping the power supply of the built-in amplifier.
No sound is produced by the system when the power output is set to
OFF.
If an external amplifier only for the subwoofer is connected, set to
ON.
Setting the Digital Output
To connect to a digitally to an audio processor, the optical digital output
must be turned ON.
If DVD Audio is used, sound is output via Ai-NET regardless of this
setting.
DVD Setup Operation
DVD Setup Operation is performed by the remote control unit.
1
Press SETUP before inserting a disc, or when in
stop mode.
The setup menu appears on the monitor.
2
Press or to select your desired setting item,
then press ENT.
Further items will be displayed.
*
1
Refer to “Audio Setup” on page 29.
*
2
Refer to “Custom Setup” on page 31.
3
Press , , or to change the setting, then
press ENT.
POWER IC ON (Initial setting) / POWER IC OFF
POWER IC OFF : Use this mode when the front and rear pre-
amplifier of the unit are used to drive an
external amplifier connected to the speakers.
In this setting, the head unit’s internal amplifier
has no output to drive speakers.
POWER IC ON : The speakers are driven by the built-in
amplifier.
OPT OUT ON / OPT OUT OFF (Initial setting)
Amplifier
Front
left
Front
right
Amplifier
Rear
left
Rear
right
Speakers
SPEAKER
RIGHT FRONT
Front
right
SPEAKER
RIGHT REAR
Rear
right
SPEAKER
LEFT REAR
Rear
left
SPEAKER
LEFT FRONT
Front
left
DVD Setup
The following 4 steps are common to each of the DVD settings.
Refer to the specific section for details.
Setting items:
LANGUAGES / TV SCREEN / PARENTAL / AUDIO SETUP*
1
/
CUSTOM SETUP*
2
RETURN
CLR
SETUP
ENT.
Numeric
keypad
(0 to 9)
LANGUAGES
CUSTOM SETUP
SETUPAUDIO
TV SCREEN
6
SETUP
PARENTAL
OFF
EN
19
WIDE
01GB00DVA9861.book Page 26 Tuesday, December 6, 2005 3:41 PM