Filter
Top Products
54-0376
3.9
Using the Remote Control
3-2 Programming the Remote Control
to Operate Other Components
In addition to controlling the mobile receiver, you
may be able to operate your TV, VCR, DVD, or AUX
components using your TracVision remote control. To
program your remote control, follow the steps below.
1. Keep the remote control aimed at the IR input (or
“eye”) for the component you want to control.
For example, if you want to program the remote
control to operate the TV, keep the remote aimed
at the TV’s IR input.
2. Press and hold the remote control’s component
button (for example, TV).
3. At the same time, press the MUTE button for two
seconds.
4. Release both buttons.
The component button should light and remain
lit. If it doesn’t remain lit, repeat Steps 1 through
4 above.
5. Repeatedly press the upper part of the
CHANNEL (CH) button.
6. Continue pressing the CHANNEL
(CH) button to step through the codes
until the component turns off,
indicating that you have found the
correct device code. If you accidentally pass a code
that responds or realize you may not have been aiming
the remote control at the component, repeatedly press
the lower part of the CHANNEL (CH) button to step
backward through the codes.
7. Press the remote control’s PWR button to verify
that you have found the proper code. The correct
code will turn the component on and off.
8. Press the component button again to lock in the
code (in this example, the TV button).
To operate a component, first press the desired
component button (DVD, VCR, AUX, TV, or SAT).
Then use the remote control buttons that apply to that
component. For example, the VOLUME (VOL) and
MUTE buttons apply only to a TV; the VCR control
buttons apply only to a VCR or DVD player.
CH
P
A
G
E