Filter
Top Products
54-0376
10.8
DIRECTV Mobile Receiver/Controller User’s Guide
Favorite Channel List Active
If a favorite channel list is active, only channels set up
in that list are accessible. Press the remote control’s
FAV button to cycle through the lists. See Section 6-1,
“Using Favorite Channel Lists,” on page 6.3 for details.
Remote Control Not Programmed
If you cannot operate a component with the remote
control, first ensure that the associated component
button (DVD, VCR, AUX, or TV) is selected. If the
correct button is selected, you need to program the
remote control to operate the component. See
Section 3-2, “Programming the Remote Control to Operate
Other Components,” on page 3.9 for details.
Program Guide Load Interrupted
If the program guide load is interrupted at startup,
certain channels may not be available temporarily.
Guide load interruptions could occur as a result of
satellite blockage (see “Satellite Signal Blocked” on
page 10.6). The missing channels will eventually be
restored as the receiver completes the program guide
download during normal operation.
Receiver Locked Up
Since your mobile receiver is a computing
component, it is susceptible to erratic changes in
power and/or signal, like any computer, and these
sudden changes can cause it to become “confused.”
To clear this condition, try pressing the remote
control’s SAT button before trying to control the
receiver. If that doesn’t work, turn off vehicle/vessel
power or the receiver’s power switch for 30 seconds,
then turn it back on.
Outside Designated Market Area (DMA)
Local channels are available only within the
Designated Market Area (DMA) used on your
account. The antenna cannot receive local channels if
you travel outside of your DMA.
System Not Set Up for All Satellites
If your antenna system supports multiple satellites,
you can choose to omit certain satellites from the
system’s list of available satellites. If you do so, you
will not be able to access channels that are carried on
those omitted satellites. For details, see Section 9-6,
“Changing the List of Available Satellites” on page 9.10.