Filter
Top Products
CAUSE
1. The power plug not connected
2. Power plug and socket
3. The power socket not switched on
1. Cables not properly connected
2. Discs scratched or dirty
3. The unit is in the mute status
1. Cables not properly connected
2. The TV set not properly adjusted
3. The video output system of this player
Does not match the TV input.
1. TV system not right
2. TV set's color saturation not properly
adjusted
3. Video output setting not right
1. No disc in the drive
2. Disc not properly placed
3. Condensation on the laser head
4. Not in the playback mode
5. Wrong disc format
6. Disc dirty
1. Disc information not well stored
2. Wrong buttons pressed
3. External static leakage into the cover
1. T V system not suitable for the disc
1. The system not properly connected
2. No disc or the disc not recordable
3. The disc finalized
4. No space left in the disc
1. The input source is not correct
2. The video output system not adequate
1. Disc error
2. Wrong time settings (system clock or recording
time)
3. The source not work properly when recording
4. Powered off
1. No space left in the recording disc
2. Too bad quality of the recording disc
SYMPTOM
No power
No sound
No picture
No color
No disc
reading
Instantaneous
function failure
Picture rolling
External signals
record failure
No monitoring
signal
Time recording
failure
Recording
abortion
REMEDY
1. Connect the power plug into the wall outlet securely
2. Plug again or change another socket
3. Switch on the power socket
1. Connect cables securely
2. Clean the discs.
3. Press the [MUTE] button again
1. Connect cables securely
2. Reset your TV set'sAV/TV status
3. Press the [IS/PS] button
1. Press the [IS/PS] button to reset the system
2. Readjust the TV set's saturation
3. Readjust video output settings
1. Load a disc
2. Reload the disc with the playback side facing down
3. Turn on the power for about 1 hour without a disc before playing
4. Press the [PLAY] button
5. Load the compatible discs
6.Carefully cleanthe discwith softclothoutwards fromthe center
1. Wait for 5-10 seconds and this unit will restore
normal playback.
2. Press the right button
3. this unit
Restart playing after turning off for 1-2 minutes
1. Adjust the TV system
1. Connect the system properly
2. Place a recordable disc
3. Replace the disc
4. Replace the recordable disc
1. Reset the signal source
2. Switch video output system
1. Reload new DVD+R, DVD+RW discs
2. Reset time recording settings
3. Ensure normal working of the source when recording
4. Switch the unit to the standby mode
1. Reload a blank disc
2. Use high quality recording disc
If you experience problems with this unit, please check the chart below for a possible solutions before
requesting servicing
Trouble shooting
APPENDIX
DVD55RW i
49.