Filter
Top Products
14
English
Owner’s Manual
TVX5653
TV Mode Operations
For your safety, the driver should not watch
the TV or operate the controls while driving.
Please note that watching and operating the
TV while driving is prohibited by law in some
countries. Also, while driving, keep the vol-
ume to a level at which external sounds can
be heard.
Watching TV
1) Press the TV/CD button 2 to select the TV
mode.
2) Press the joystick # up (w) or down (z) to
select TV1 or TV2. Each time the joystick #is
pressed up (w) or down (z), the setting is
switched in the sequence shown below.
WARNING
3) Press the joystick # to the left (Å) or right
(Î) to select the channel.
Seek tuning
Keep pressing the joystick # to the left (Å) or
right (Î) for about half a second.
The seek tuning mode is selected when you
keep pressing the joystick. Tuning will stop auto-
matically at a channel where a broadcast is
received.
*When seek tuning has stopped before or after a
broadcast channel, press the channel button
again.
Manual tuning
Press the joystick # to the left (Å) or right (Î)
to select the channel.
The channel number appears at the top left of
the screen.
*Each time the joystick # is pressed, the channel
number is incremented or decremented by 1.
*The channel number remains on the screen for
about 5 seconds.
*To ensure that the channel number is displayed all
the time, refer to the section on permanently dis-
playing the channel (page 15), and perform the
necessary settings.
Preset memory function
The number of preset channels which can be
stored in the memory is:
• 6 stations for TV1
• 6 stations for TV2
Any station can be stored in any preset channel.
Auto store function
The channels received automatically are auto-
matically stored in the preset channels.
The setting procedure for the preset channels is
the same for TV1 and TV2.
1) Press the SHIFT button 3 to display the
menu screen.
*The menu screen remains displayed for about
5 seconds.
*Perform the next operation while the menu
screen is displayed.
2) When the AS (auto store) button 6 is
pressed, the broadcast stations are automat-
ically stored in the memory starting with the
one following the station now received.
Notes:
• The memory contents are returned to the
default settings when the battery is replaced or
the power supply is otherwise suspended.
• The signal conditions are sometimes such that
a channel without a station is stored in the
memory.
• Some stations may not be stored if their signals
are too weak in the reception area.
• When a station could not be stored or a chan-
nel without a station has been stored in the
memory, refer to the section on the manual
memory function which follows, and perform
the settings again.
TV1
VTR
TV2
Total of 12 stations
}