TVX5653
10
English
Owner’s Manual
6. CAUTION ON HANDLING
Cleaning
•
Cleaning the cabinet
Use a soft, dry cloth and gently wipe off the
dirt.
For tough dirt, apply some neutral detergent
diluted in water to a soft cloth, wipe off the dirt
gently, then wipe again with a dry cloth.
Do not use benzene, thinner, car cleaner, etc.,
as these substances may damage the cabinet
or cause the paint to peel. Also, leaving rubber
of plastic products in contact with the cabinet
for long periods of time may cause stains.
• Cleaning the LCD panel
The LCD panel tends to collect dust, so wipe
it off occasionally with a soft cloth.
The surface is easily scratched, so do not rub
it with hard objects.
Concerning the wide
screen
• A wide-screen TV comes with a function for select-
ing various screen modes. If you select a screen
mode that differs from the picture ratio of the TV
program or other software media, you will not be
able to view the original pictures as was originally
intended. Bear this point in mind when selecting
the screen mode.
For a longer service life, be sure to read the fol-
lowing cautions.
• Be sure to store the LCD panel inside the source
unit when parking the car outdoors for long peri-
ods of time.
The LCD panel will operate properly in a tempera-
ture range of 0 to 60°C.
• Don’t allow any liquids on the set from drinks,
umbrellas etc. Doing so may damage the internal
circuitry.
• Do not disassemble or modify the set in any way.
Doing so may result in damage.
• Do not draw the LCD panel out and use it as a tray.
Also, subjecting the LCD panel to shocks may
result in breakage, deformation or other damage.
• Do not let cigarettes burn the display. Doing so
may damage or deform the cabinet.
• If a problem should occur, have the set inspected
at your store of purchase.
• Do not insert objects or poke in the space between
the LCD panel and the source unit when the panel
is tilted.
• Do not place anything on the display when the
LCD panel is tilted.
• In extremely cold weather, the movement of the
picture may be slow and the screen may be dark,
but this is not a malfunction. The set will work nor-
mally once the temperature increases.
• Small black and shiny dots inside the LCD panel
are normal for LCD products.
• The LCD panel may stop temporarily when it is
opened or closed when the engine is stopped or
when it is cold. This is not a malfunction. If this
happens, repeat the operation.
• The remote controller may not work if the remote
control sensor is exposed to direct sunlight.
• Do not hold on the screen when adjusting the
angle of the LCD panel. Doing so may damage it.
• Do not leave droplets of water on the LCD panel
since they can cause discoloration and stains. In
addition, entry of moisture inside the unit can
cause malfunctioning. Any drops of water on the
panel should be removed immediately using
absorbent cotton or a soft cloth.
• Do not insert objects into the video input jack.
• The fluorescent light used behind the screen even-
tually wears out. It should be replaced if the pic-
ture becomes extremely dark or flickers.