Denon DVD-1000 DVD Player User Manual


 
Y
CB
CR
COMPONENT
VIDEO OUT
R
L
AUDIO
OUT
VIDEO
OUT
S-VIDEO
OUT
DIGITAL OUT
(
PCM/BITSTREAM
)
OPTICALCOAXIAL
VIDEO IN
11
ENGLISH
(3) Connecting to a AV amplifier with a built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player’s digital
audio output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence
of a movie theater or concert hall.
TV
DVD-1000
Digital audio input
connector (COAXIAL)
Front speaker (left)
Surround speaker (left)
Center speaker
Digital audio input
connector (OPTICAL)
AV amplifier with a built-in decoder
(AV control center)
Front speaker (right)
Subwoofer
Surround speaker (right)
2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)
NOTE:
Store the dust cap in a safe place, and be careful not to
lose it.
When not using the terminal, attach the cap to protect
the terminal from dust.
Dust cap Line up in proper direction
Remove the dust cap, line up the cable in the proper directly, then
insert it securely as far as it goes.
NOTES:
Set the
AUDIO OUTPUT
in
AUDIO SETUP
in
SETUP
setting to
DIG./NORMAL
. (See page 38.)
Set the
TV TYPE
in
VIDEO SETUP
in
SETUP
comply with your TV's video format. When the TV is NTSC formated, set to NTSC.
(See page 37.)
Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using a
decoder, etc., that is not DTS-compatible.
To power outlet
Optical fiber cable
(commercially available)
75/ohms pin-plug
cable (commercially
available)