Filter
Top Products
- 43 -
Channel Preset
Your VCR can receive a maximum of 181 channels as shown below by presetting the channels into memory.
(VHF: 2 to 13, UHF: 14 to 69, CATV: 1 to 125)
Preparation
• Make sure that the cable (antenna or CATV) is connected to the IN terminal on the rear of the VCR.
1. Press the MENU button.
Select “CHANNEL PRESET” with or button and then press the ENTER button.
Notes:
• Automatic tuning will not start unless the arrow is at “CH SET-AUTO” position.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to normal.
• If the power is interrupted for more than 5 seconds, AIR/CATV selection must be set again.
• Automatic tuning will be interrupted if the VCR ON/OFF or MENU button is pressed before the screen returns
to normal.
2. Select “AIR” or “CATV” with
or button and then press the button.
EX: AIR
3. Set “CH SET” to “AUTO” with
or button and then press the ENTER button.
4. The auto tuning will start.
The channel display will count up and when finished, the screen returns to normal.
SELECT :
ENTER : SET
MENU
TIMER
CLOCK
SET UP
LANGUAGE
CHANNEL PRESET
EXIT : MENU
MENU
CHANNEL PRESET
AIR / CATV CATV
CH SET AUTO
AIR
MANUAL
AIR / CATV CATV
CH SET AUTO
AIR
MANUAL
S
02
AUTOMATIC TUNING .
PLEASE WAIT .
Normal
Screen
VCR Setup
(continue on next page)(continue on next page)
(continue on next page)(continue on next page)
(continue on next page)
ENTER
ENTER