Filter
Top Products
VCZ625 33
9. IN CASE OF DIFFICULTY
Power does not
turn on.
(No sound is
produced.)
Nothing happens
when buttons are
pressed.
The remote control
unit does not work.
Sound is bad
directly after power
is turned on.
Magazine cannot
be loaded.
“No Disc” sign
appears when
searching for discs.
Sound skipped.
Problem
Fuse is blown.
Incorrect wiring.
The setting of the
CeNET/STAND
ALONE select
switch is not correct.
The microprocessor
has malfunctioned
due to noise, etc.
The microprocessor
has malfunctioned
due to noise, etc.
The batteries are
dead.
The remote control
receiver connector is
not deeply inserted.
Water droplets may
form on the internal
lens when the car is
parked in a humid
place.
Magazine inserted
wrongly.
A magazine is
already in the player.
Distorted magazine.
Disc inserted
upside-down.
Moisture or dirt on
disc.
Lock screw left
attached.
Replace with a fuse 3A of the same amperage. If the fuse blows
again, consult your store of purchase.
Consult your store of purchase.
Set the switch to the correct position.
Press the reset button with a thin rod.
Note;
When the reset button is pressed, turn off the ACC power.
Press the reset button with a thin rod.
Note;
When the reset button is pressed, turn off the ACC power.
Replace them with new ones.
Insert the connector deeply.
Let dry for about 1 hour with the power on.
Insert correctly.
Eject the magazine and insert the other.
Buy New Magazine CAA-397.
Read the section on “Inserting The Disc” carefully and reinsert
the Disc correctly.
Wipe disc free of moisture and dirt.
Remove the lock screw.
Cause Measure
Reset button