Filter
Top Products
34 VCZ625
lf the same phenomenon still occurs after checking the above, or it is impossible to remove the magazine,
please consult your local dealer.
10. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. When the
reset button is pressed, frequencies of TV/radio stations, titles, etc. stored in the memory are cleared.
If the problem persists, turn off the power and consult your store of purchase.
Error Cause Measure
The failure of the changer itself considered.
1. A DVD/CD cannot be played due to
scratches, etc.
2. A DVD/CD cannot be played due to
the defective pick-up part.
3. The disc is placed up side down.
Disc region code incorrect.
The view is limited.
Consult your store of your purchase or
the Clarion repair window.
Replace with a non-scratched,
non-warped-disc.
Replace the disc with face up.
Use a disc with the correct region code.
Release the view limitation or change the
parental level.
(See the subsection “Setting up the
parental level”.
MECHA ERROR
PARENTAL
VIOLATION
DISC ERROR
(ERROR6)
WRONG REGION
Noise, skipping
Mechanism does
not function.
Problem
The installation
selector levers are
set to different
positions on both
sides.
The unit installation
direction and the
installation selector
lever positions do
not match.
Disc bent or badly
damaged.
Disc is very dirty.
Mechanical error.
Set the installation selector levers to the same position on both
sides.
Set the unit installation direction and the installation selector lever
positions to match each other. When installed at an angle,
change the installation selector lever to a position (H, 45˚, V) not
prone to noise or sound loss.
Compare with another disc. If bad, discard the damaged disc.
Clean the disc.
1. Reading the section “INSTALLATION” of Installation Manual
thoroughly, check the three angle of installation selector levers
are properly set. If not, set them at the proper position for the
angle of installation.
2. Check whether The magazine can be ejected by pressing the
magazine eject button, then insert a new magazine.
Cause Measure