Filter
Top Products
VCZ625 11
7. PREPARATION (Setting a Disc)
Inserting the disc
1. Put your finger on the disc holder release knob
and draw out the disc holder.
2. Insert a disc into the concave portion of the
disc holder with its label side (printed side with
a title, etc.) facing up.
3. Press in on the disc holder until it locks
securely into the magazine. After loading a
disc, make sure that it is correctly loaded.
CAUTION
Look through the magazine opening and
check whether or not the disc is tilted.
If the disc holder does not slide in fully, or
slides with difficulty, it is possible that the disc
is not correctly loaded. Reload in such cases.
Setting a disc into the magazine
CAUTION
Pulling strongly on the disc holder may cause
it to come out of the magazine. In such cases,
press in on the disc holder tabs and re-insert
into the magazine. Be sure that the disc holder
is correctly inserted.
Extracting the disc
Take out the disc after pulling out the disc holder.
Note:
• When taking out the disc do not let your fingers
touch the signal side of the disc.
■
Setting the Magazine into the Unit
Inserting the Magazine
1. Slide the open slide lever to right (to open the
front door).
2. When using the unit in a vertical position, open
the front door completely by hand.
Magazine
Disc holder
Release
knob
Lever
Release
knob
Magazine
Disc Holder
Label side