Filter
Top Products
16
Understanding the basicsDX-19L200A12
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press POWER to turn on your TV.
3 Press POWER again to turn off your TV. Your TV
enters Standby mode.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The Input Select
list opens.
2 Press or to highlight the video input source,
then press ENTER, or press the number button that
corresponds to the input you want.
Selecting a channel
To select a channel:
•Press CH+ or CH– to go to the next or previous
channel on the memorized channel list.
• Press the number buttons to enter the channel
number you want, then wait for the channel to
change or press ENTER to immediately change the
channel.
• To select a digital sub-channel, press the number
buttons to select the main digital channel, press
.
,
then press the number button for the sub-channel.
Wait for the channel to change, or press ENTER to
immediately change the channel.
•Press RECALL to go to the last viewed channel. Press
RECALL again to return to the channel you were
watching.
Adjusting the volume
To adjust the volume:
•Press VOL+ or VOL– to increase or decrease the
volume.
•Press MUTE to turn off the sound. Press MUTE again
to turn the sound back on.
Using the Sleep setting
To set the TV to turn off after a preset amount of time,
press SLEEP on the remote control. The clock adds 10
minutes for each press of the SLEEP button (Off, 0h 10m,
0h 20m, 0h 30m, 0h 40m, 0h 50m, 1h 0m, 1h 10m, 1h 20m,
1h 30m, 1h 40m, 1h 50m, 2h 0m). After the sleep time is
programmed, the display appears briefly every ten
minutes to remind you that the sleep timer is operating.
To confirm the sleep timer setting, press SLEEP and the
remaining time is displayed for a few seconds. To cancel
the sleep timer, press SLEEP repeatedly until the display
turns to Off.
Viewing program information
To view channel information:
•Press INFO to view an information banner. The
information banner shows the current program
information such as channel number, video input
source, and resolution.
• Digital channel information—Displays the
channel number, station name, channel label,
broadcast program name, TV rating, signal type,
audio information, resolution, CC mode, current
time, and current program start and end times.
• Analog channel information—Displays channel
number, channel label (if preset), signal type,
audio information, and resolution.
Using the on-screen menus
Input Select
0.TV
1.Video
2.Component
3.HDMI
[0-4]:Select
4.PC
Notes
• Depending on the signal source selected, you
may see different options on your screen. The
following menus are shown in TV mode.
• Menus in this manual are described in TV mode,
unless otherwise indicated.
• The screens shown in this manual are for
explanation purposes and may vary from the
actual screens on your TV.
62-1 HDTV_Moving_Picture...
CH-1 TV-MA
Digital Air
No Program Information is available
Sleep Timer
Off
English
Full
1080i
14
Analog Cable
Sleep Timer
Off
Mono
Full
480i
G
DX-19L200A12_11-0606 MAN_ENG_V1.book Page 16 Thursday, November 3, 2011 10:06 AM