Filter
Top Products
14
Using your TV
Using your TV
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into a power outlet.
2 Press (power). Your TV turns on.
3 Press again to turn off your TV. When you turn off your TV, it
goes into standby mode.
Warning: When your TV is in standby mode, it is still receiving power. To
completely disconnect power, unplug the power cord.
Note: If your TV does not receive an input signal for several minutes, it
automatically goes into standby mode.
Using the remote control
• Point the remote control toward the remote control sensor on the
front of your TV.
• Make sure that no objects are between the remote control and
the remote control sensor.
• Do not expose the remote control to shock.
• Do not expose the remote control to liquids or high humidity.
• Do not place your TV in a location where sunlight or bright light
shines on the remote control sensor. This can interfere with the
signal from the remote control.
The following illustration shows the best angle for using the remote
control.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The INPUT SOURCE menu
opens.
2 Press or to select the video source, then press ENTER. You
can select:
•TV
•AV
•S-Video
• Component1
• Component2
•HDMI1
•HDMI2
•VGA
You can also select the input source using the following remote control
buttons:
• COMP—Press once to select Component1. Press twice to select
Component2.
• HDMI–Press once to select HDMI1. Press twice to select HDMI2.
• VIDEO—Press once to select AV. Press twice times for S-Video.
• TV—Press to select TV.
Selecting the TV signal source
The first time you turn on your TV, you must select the TV signal source.
Your TV stores this information.
You do not need to change the TV signal source unless it changes. For
example, you change from an outside antenna to cable TV.
To select the TV signal source:
1 Press MENU. The on-screen menu opens.
2 Press or to select Channel, then press . The Channel
menu opens.
3 Press or to highlight Air/Cable, then press or to select
Air (antenna) or Cable (cable or satellite TV).
4 Press EXIT to close the menu.
16.4" (5 m)
Picture Mode
Contrast
Brightness
Tint
Color
Color Mode
Picture Time Setup Lock Channel
Standard
50
50
0
50
Cool
Select Move
MENU
Exit
Sharpness
50
Auto Scan
Favorite
Show/Hide
Channel No.
Channel Label
DTV Signal
Picture Time Setup Lock Channel
Good
Select Move
MENU
Exit
WGBH-SD
2-1
:
Air/Cable
Air