Filter
Top Products
17. Another dialog box “PC ADJUSTMENT DISPLAY 2” will appear and the parameter data for the Mode you have selected is
shown in this dialog box.
18. Move the arrow to an adjusting item you want to adjust by pressing the POINT UP/DOWN BUTTON(s).
19. To increase the level, point the arrow to A and then press the SELECT (REAR CLICK) BUTTON. To decrease the level,
point the arrow to 7 and then press the SELECT (REAR CLICK) BUTTON.
20. If you want to store the settings to the memory, move the arrow to Stored and press the SELECT (REAR CLICK) BUTTON.
When you have stored the settings, you will see “OK ?“ as a confirmation. Move the arrow to Yes and then press the SELECT
(REAR CLICK) BUTTON.
21, To recall the parameter data before settings, move the arrow to Reset and then press the SELECT (REAR CLICK) BUTTON.
When you have reset the settings, you will see “OK ?“ as a confirmation. Move the arrow to Yes and then press the SELECT
(REAR CLICK) BUTTON . You can adjust the settings again if needed.
22. To quit the MENU, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON.
23. If you quit the MENU without storing the settings to the memory, the parameter data you changed will not be kept.
24. The stored settings are permanently kept even if the MAIN ON/OFF is switched off.
ITEM FUNCTION
CLAMP
Adjustment of the clamp level. When the image has a dark bar, try this adjustment
HEIGHT
Expanding or compressing level for the vertical direction
WIDTH
Expanding or compressing level for the horizontal direction