Filter
Top Products
15
EN
W
ATCHING TV
OPTIONAL SETTING DVD SETTING TROUBLESHOOTING INFORMATIONOPERATING DVDINTRODUCTION
WATCHING TV
PREPARATION
INITIAL SETTING
Channel Selection
Select channels by using [CH.
K
/ L] or [the Number buttons].
Use
[CH.
K
/ L] or [the Number buttons] to select the
memorized channels.
or
or
Using [the Number buttons]
TV
- When selecting analog channel 12
DTV
- When selecting digital channel 12-1
• Be sure to press [–/ENT.] before entering the minor
channel number.
• Press [CH. RECALL
] to return to the previously
viewed channel.
• When you select a channel larger than 100, press
[+100] first. Then use [the Number buttons] to press
the lower 2-digit numbers.
• Only [the Number buttons] can be used to select the
non-memorized channels.
About digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously. Therefore, you can
select more than one program per major channel since
digital broadcasting technology distinguishes between
multiple channels broadcast by a single network.
CH4
CH4
(high denition TV)
18:00
18:30
19:00
19:30
20:00
20:30
CH4-1
CH4
CH4
No signal
No signal No signal
CH4-2
ATSC (digital mode)
CH4
NTSC (analog mode)
[Air Time]
No signal
CH4-1CH4 CH4-2
: change automatically
major channel
: change manually by using [CH. K/L]
minor channel
Although, you cannot watch the high definition TV
(HDTV) program, the unit converts the HDTV signal
down to the standard definition TV signal.
Note:
• “NO SIGNAL” will appear on the TV screen after the minor
channel broadcast is over.
5 Volume Adjustment
This section describes how to adjust the volume.
The mute function, which turns the sound off and on, is also described.
Use
[VOL.
X
/
Y
] to adjust the audio volume
.
or
VOLUME 20
• The volume bar will be displayed at the bottom of the
TV screen when adjusting the volume.
• The volume bar will automatically disappear in a few
seconds.
Press [MUTE ] to turn off and on the sound.
MUTE 20
• “MUTE” is displayed on the TV screen.
Press [MUTE ] again or use [VOL.
X
/
Y
] to recover
the original volume.
Switching Each Input Mode
You can easily switch with the remote control to the DTV (ATSC) and TV
(NTSC) or to access external devices when they are connected to the unit.
Press [INPUT] repeatedly to cycle through the input
modes.
ANALOG MODE
DIGITAL MODE
VIDEO1
VIDEO2
PC
• To use the video or S-video input jack on the unit,
select “VIDEO1”.
• To use the component video input jacks on the unit,
select “VIDEO2”.
• To use the PC input jack on the unit, select “PC”.
Note:
• When you switch the analog mode to the digital mode,
it may take a while until the digital channel selection is
completed. “NOW SCANNING“ is displayed while switching
the modes.
5
5
A84N3UH_A84N1UH_LD195EM8 2_LD19515 15A84N3UH_A84N1UH_LD195EM8 2_LD19515 15 2008/02/15 14:31:182008/02/15 14:31:18