Filter
Top Products
48 Making Detailed Adjustments
■ Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
Auto to let the projector automatically interpret the signal;
or select
YCbCr or YPbPr to manually select your video equipment’s signal.
■ Trigger Out
Turn on this setting if you want the Trigger out port to output a 12-volt signal while
the projector is operating. You can use this to raise or lower your projection screen.
Note: If you change this setting, the new setting will take effect the next time you turn the
projector on.
■ Sleep Mode
Turn off this setting if you don’t want the projector to enter sleep mode. (Sleep mode
shuts the projector off automatically when there is no video signal.)
Select
5min., 10min., or 30min. as the length of time before shutoff; decreasing the time
conserves power and extends the life of the lamp.
To turn the projector back on, press the Ppower button on the remote control or the
projector.
■ Child Lock
Lets you lock the Ppower button on the projector’s control panel to make it more
difficult for a child to turn on the projector. See page 32 for more information.
■ Control Panel Lock
Lets you disable all the buttons on the projector’s control panel to prevent the image from
being accidentally changed once it is adjusted. See page 32 for more information.
■ High Altitude Mode
Adjusts the speed of the fan so it can properly cool the projector at higher altitudes. Turn
this setting on if you are using the projector at an altitude of 4900 feet (1500 meters) or
higher.
Settings > Input Signal > Component
Settings > Trigger Out
Settings > Sleep Mode
Settings > Child Lock
Settings > Control Panel Lock
Settings > High Altitude Mode