Filter
Top Products
Problem Solving 63
The warning light is flashing orange and the light is flashing red.
High-speed cooling is in process. If the projector gets too hot again, projection stops
automatically. Make sure the projector is at least 8 inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 55). If you are using the projector at an
altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 52).
The warning light is flashing orange.
The lamp needs to be replaced. See page 57.
The light is red and the warning light is red.
The projector is too hot and has turned off the lamp. Make sure the projector is at least 8
inches (20 cm) away from the wall.
Clean or replace the air filters if necessary (see page 55). If you are using the projector at an
altitude above 4900 feet (1500 meters), turn on High Altitude Mode (see page 52).
Let the projector cool for five minutes. When the light turns orange, press the button to
turn the lamp back on. If the status doesn’t change, wait a few minutes, then unplug the
projector and contact Epson. See page 69.
The light is red and the warning light is flashing red.
The lamp may be incorrectly installed, the lamp cover may be loose, or the lamp may be
broken. Turn off the power, wait a few minutes (or wait 1 hour if you’ve been using the
projector), and check the lamp. See page 59. If the lamp is broken, or the lights continue to
flash after you turn the power back on, unplug the projector and contact Epson. See page 69.
The light is red and the warning light is flashing red.
The projector has a problem with its fan or temperature sensor. Wait a few minutes, then
unplug the projector and contact Epson. See page 69.
The light is red and both warning lights are flashing red.
The projector may have an internal error. Press . Then unplug the power cable, plug it in
again, and press again. If the lights continue to flash, unplug the projector and contact
Epson. See page 69.
The light is red and both warning lights are red.
The projector may have an auto iris or ballast error. Unplug the projector and contact Epson.
See page 69.