Filter
Top Products
24
You see the following screen:
6. For Mail Notification Settings, select
ON and press Enter on the
remote control.
7. Highlight the
IP address of SMTP server box and press Enter.
The outline of the box turns green to indicate you are in input
mode. You can enter numbers between 0 and 255. However, you
cannot use the following IP addresses: 255.255.255.255,
224.0.0.0, or 127.x.x.x (where x is a number between 0 and 255).
8. Highlight the
Port Number box and press Enter. Then enter the
SMTP server port number. The default value is 25, but you can
enter numbers between 1 and 65535.
9. Highlight the box for
Destination address 1 and press Enter.
Enter the e-mail address for the first computer that you want to
receive e-mail alerts. You can enter a maximum of 53 single-byte
alphanumeric characters.
10. If you want to send e-mail alerts to one or two other computers,
enter addresses for those computers in
Destination address 2
and
Destination address 3.
11. Select the conditions under which an e-mail alert will be sent.
note
Use the up and down
buttons on the remote
control to enter letters and
numbers. You will also see
punctuation marks, such as
a period (.) and symbols,
such as @. When you see the
letter or symbol you want,
press
Enter. Then press the
right arrow to move to the
next position. To correct a
mistake, press the left arrow
to return to the previous
position.
Bernslip.fm Page 24 Friday, December 12, 2003 3:02 PM