Epson LS47P1 Projection Television User Manual


 
40 Setting Up and Controlling Channels
4 First make sure the correct television source type is selected for Antenna 1 and/or
Antenna 2. Select TV for broadcast television via an antenna outside your house. Select
CATV for cable television via a cable service line brought into your house.
If you need to change the option, press Select d or Select u to highlight the
Antenna 1 or Antenna 2 setting, then press Prev < or Next > to change the option.
5 If you connected a source to the ANT 2 connector, press Select d to highlight the Use
of Ant. 2 setting, then press Prev < or Next > to select On.
6 Press Select d to highlight Auto Program, then press Enter.
The menu disappears and Auto Program Setting appears in the middle of the screen
as the TV begins searching for available channels. It reports the current channel in the
upper right corner. This process takes a few minutes, depending on the number of
channels available.
When it’s finished, you return to the Channel menu.
If the automatic program doesn’t detect all of your available channels or if you want to set up
the TV to skip certain available channels, follow the steps in the next section.
Note
If you have another TV
signal source connected to
the other antenna
connector (ANT 1 or 2),
press the TV/Video button
to switch to that source.
Then repeat steps
1 through 5 to set up the
channels on that source
too.