Escient DVDM-100 DVD Player User Manual


  Open as PDF
of 107
 
PAGE 21
FireBall™ DVDM-100 User’s Manual
Connecting Kenwood CD/DVD Changers
FireBall requires that you connect each changer to the back panel using audio and control cables.
Follow these steps to connect your Kenwood DVD/CD changers to your FireBall:
1. Locate the RS-232 serial cable that came with your Kenwood changer. This is the black cable with female DB-9
connectors on each end.
2. Connect one end of the RS-232 serial cable into Communication Port number 1, on the back of your FireBall.
3. Connect the other end of the RS-232 serial cable into the “RS-232C” port on the back of your changer.
4. Locate the stereo RCA audio patch cable that came with your changer.
5. Connect one end of the RCA audio cable into the Analog In jacks number 1 on the back of your FireBall
6. Connect the other end of the RCA audio cable into the Analog Line Out jacks on the back of your changer.
• Ifyouhavemorethanonechanger,repeatthese
steps to connect the additional changers to
communications ports and audio jacks 2 and 3
respectively.
• Forthebestaudioquality,youshouldalso
connect digital optical audio or coax cables (not
included) between your changers and FireBall.
• Forthebestvideoquality,youshouldalso
connnect component video cables (not included)
between your changers and FireBall.
• Tocontrolpoweronandpoweroffforthe
Kenwoodchangeryoumustconnecttheincluded
1/8” male to male cable between the “S-Link/
IROut”jackontheFireBallandthe“DVD
CONTROL”jackontheKenwoodchanger.
 previous next