Filter
Top Products
3-9Digital Display Scaler • Operation
Advanced Configuration menu
Figure 3-8 is a flowchart that shows an overview of the Advanced Configuration
menu, the submenus, and the available settings.
MENU
NEXT
NEXT
To reset the scaler, press
and hold the Freeze button
until the reset message
displays.
*Adjust knobs do not affect
this submenu
RGB delay time (in seconds)
• 0.0 to 5.0 seconds in 0.1 sec.
increments (0.7 second default)
Set top and bottom blanking
• 0 to 237, top and bottom
(Adjust for top,
Adjust for bottom)
NEXT
NEXT
NEXT
NEXT
NEXT
Smooth edges
• On (default)
• Off
Set test pattern type
• Off (default)
• Color Bars
• Crosshatch
• 4 x 4 crosshatch
• Grayscale
• Crop
• Alt Pix
• Film aspect 1.78
• Film aspect 1.85
• Film aspect 2.35
• Ramp
Display blue and sync only
• On
• Off (default)
Use either Adjust
knob to adjust the
submenus
Output
Configuration
Top Blanking Bot
000 000
Press and Hold
FREEZE to Reset
RGB Delay
0.7 Seconds
Advanced
Configuration
MENU
Exit
Menu
Test Pattern
Off
Edge Smoothing
OFF
<
ON
>
Blue Mode
OFF
<
ON
>
Figure 3-8 — Advanced Configuration menu flowchart
Edge Smoothing submenu
The Edge Smoothing submenu turns the edge smoothing feature on and off. Edge
smoothing smooths edges of a picture by minimizing the differences between
pixels.
Use either the Adjust
knob or the Adjust knob to select On (the default) or Off.
Blue Mode submenu
The Blue Mode submenu turns the blue mode feature on and off. Blue mode is
helpful in the setup of the connected displays’ monitors. In the blue mode, only the
sync and blue video signals are passed to the display.
Use either the Adjust
knob or the Adjust knob to select On or Off (the default).
Test Pattern submenu
The Test Pattern submenu selects from among several test patterns. The test
patterns are helpful when adjusting the connected displays for color, convergence,
focus, resolution, contrast, grayscale, and aspect ratio.
Use either the Adjust
knob or the Adjust knob to select a test pattern. The
options are: Off, Color Bars, Crosshatch, 4 x 4 Crosshatch, Grayscale, Crop,
Alternating Pixels, Film Aspect Ratio 1.78, Film Aspect Ratio 1.85, Film Aspect
Ratio 2.35, and Ramp. The default is Off.
Blanking submenu
The Blanking submenu displays and sets the top and bottom line blanking.
Use the Adjust
knob to adjust the top blanking and the Adjust knob to adjust
the bottom blanking.
RGB Delay submenu
The RGB Delay submenu displays and sets the RGB delay. With RGB delay, the
DDS 402 switches to the new sync signal before switching RGB (video) signals.
This allows a brief delay for the displays to adjust to the new sync timing before
displaying the new picture, which will appear without glitches. RGB delay is also
known as Triple-Action Switching or video mute switching.
Use either the Adjust
knob or the Adjust knob to select the blanking period
(RGB delay time) from 0 seconds to 5 seconds in 0.1 second steps. The default is 0.7
seconds.