Filter
Top Products
26
continued on next page
References
Trouble Checks
Sometimes problems can be easily solved by checking a few basic things. Check below before
you call for help or take your VCR to an Authorized GE VCR Servicenter.
No power
VCR does not respond to remote
Poor or no picture for normal TV viewing
Snowy or no picture during playback
Streaks in picture during normal playback
Time counter not working or time counter does
not change during zero search feature
Will not record or play
Will not record
Can’t stop VCR recording
• Plug VCR into an operating outlet.
• Check connections.
• Remove batteries and hold down one or more buttons for several seconds to
drain the microprocessor inside the remote and reset it. Re-install the
batteries and try remote again.
• Aim remote at VCR with no objects between them.
• Change batteries.
• Press
TV•VCR to turn VCR indicator off.
• Switch TV to an active channel.
• Check antenna connections.
• Press
TV•VCR to turn VCR indicator on.
• Check TV channel selected (3 or 4) to make sure it matches the channel
selected with
CH3 CH4 switch on back of VCR.
• Check TV’s fine tuning.
• Check video cable connections between VCR and TV monitor.
• Set TV monitor to video input channel.
• Try another tape.
• Some snow/streaks are normal during search, stop action, frame advance,
and slow-motion playback.
• Press the
TRACKING button on the remote or VCR to move streaks up or
down and out of the picture.
• Check tape — it may be worn out or of poor quality.
• The time counter does not advance during unrecorded portions of tape.
When an unrecorded segment of tape is encountered, the time counter will
hold its count until recorded material is detected again.
• A minus (–) appears in front of the time if you rewind the tape farther back
than a counter reading of
0:00:00.
• No cassette in VCR.
• Eject and re-insert cassette.
• Broken tape — try another cassette.
• VCR is in pause mode. Press
PAUSE on remote.
• Safety tab removed from cassette.
• Make sure the line indicator (
AU) does not appear in the display panel for
normal recording from the VCR’s tuner. Press
INPUT on the remote to turn
the line input off.
•
Press POWER on the VCR twice.
Trouble Here's what to try: