Filter
Top Products
36 DVS USER’S GUIDE
Open “Speaker Setup”
During playback of a DVD with 5.1 channel
sound, press VOL. SETUP on the remote control.
Select Channel Delays
Use the UP/DOWN or LEFT/RIGHT buttons to
highlight the center channel delay (to the right of
the Center Speaker icon) or surround channel
delay indicator (bottom center) , then press
ENTER.
Set Center Channel Delay
Use the UP/DOWN button to set the center
channel delay from 0-5ms, in 1ms increments,
then press ENTER.
Set Surround Channel Delay
Use the UP/DOWN button to set the surround
channel delay from 0-15ms, in 3ms increments
(i.e., 0, 3, 6, 9....15ms), then press ENTER.
NOTE:
The VOL. SETUP key is not active during STOP or
while playing a CD or VCD. To set channel
delays in these modes, follow the steps on page
37 to access the Speaker Setup menu.
1
2
3
Channel Delays
Ideally all of your speakers
will be the same distance
from your primary listening
area. If not, you can set
Channel Delays for your
center and surround speakers
so all audio signals arrive at
the same time.
4
Calculating Channel Delays
1 Measure the distance from your primary
listening area to your front speakers; e.g. 10
feet. Use this as your reference distance.
2 Now measure the distance from the primary
listening area to your center speaker; e.g. 7 feet.
3 Calculate the difference; e.g. 10 feet minus 7
feet = 3 feet.
4 Assume 1 ms of delay for each 1 foot of dis-
tance, e.g. set the Center delay to 3ms.
5 Repeat steps 2-4 for the surround speakers; e.g.
10 feet minus 4 feet = 6 feet, or 6 ms delay.
Note: If the center or surround distance is equal
to or greater than the reference distance, set the
delay to 0 ms.
Sub
10’10’
7’
4’
4’