Filter
Top Products
Safety Precautions
Safety Precautions 1
Safety Precautions
Set up
Do not place the Plasma TV on sloped or
unstable surfaces.
■ The Plasma TV may fall off or tip over.
Do not place any objects on top of the
Plasma TV.
■ If water spills onto the Plasma TV or foreign
objects get inside it, a short-circuit may occur
which could result in fire or electric shock. If any
foreign objects get inside the Plasma TV, please
consult an Authorized Service Center.
Do not cover the ventilation holes.
■ Doing so may cause the Plasma TV to overheat,
which can cause fire or damage to the Plasma TV.
If using the pedestal, leave a space of
3 15/16 inch (10 cm) or more at the top,
left and right, 2 3/8 inch (6 cm) or more at
the bottom, and 2 3/4 inch (7 cm) or more
at the rear. If using some other method for
setup, leave a space of 3 15/16 inch (10 cm)
or more at the top, bottom, left and right,
and 3/4 inch (1.9 cm) or more at the rear.
Avoid installing this product near electronic
equipment that is readily affected by
electromagnetic waves.
■ It may cause interference in image, sound, etc. In
particular, keep video equipment away from this
product.
AC Power Supply Cord
The Plasma TV is designed to operate on
120 Vv , 50/60 Hz.
Securely insert the power cord plug as far as
it will go, and use the clamp to secure it. (See
“AC cord” on page 7.)
■ If the plug is not fully inserted, heat may be
generated which could cause fire. If the plug is
damaged or the wall socket plate is loose, they
should not be used.
Do not handle the power cord plug with wet
hands.
■ Doing so may cause electric shocks.
Do not do anything that might damage the
power cable. When disconnecting the power
cable, hold the plug, not the cable.
■ Do not make any modifications to, place heavy
objects on, place near hot objects, heat, bend,
twist, or forcefully pull the power cable. Doing so
may cause damage to the power cable which can
cause fire or electric shock. If damage to the cable
is suspected, have it repaired at an Authorized
Service Center.
If the Plasma TV will not be used for a long
period of time, unplug the power cord from
the wall outlet.
If problems occur during use
If a problem occurs (such as no picture or no
sound), or if smoke or an abnormal odor is
detected from the Plasma TV, unplug the
power cord immediately.
■ Continued use of the TV under these conditions
might cause fire or permanent damage to the unit.
Have the TV evaluated at an Authorized Service
Center. Service to the TV by any unauthorized
personnel is strongly discouraged due to its high
voltage dangerous nature.
w
Keep unneeded small parts and other
objects out of the reach of small children.
These objects can be accidentally
swallowed. Also, be careful about
packaging materials and plastic sheets.
mb5poetv.book Page 1 Wednesday, June 29, 2005 12:42 PM