HP (Hewlett-Packard) HP z558 Flat Panel Television User Manual


 
HP Digital Entertainment Center TV/Display Setup Guide 3
4 Turn on the TV/Display power. Turn power on to all other connected audio and video devices.
5 Determine the formats that the TV/Display supports. For example: 480i, 480p, 720p, or 1080i.
Refer to your TV/Display documentation.
You may also find the TV supported format on the TV cabinet, or on the OSD (onscreen display).
Specifications for your TV model may also be available on the Web.
6 Set the TV/Display input to match the HP Digital Entertainment Center video cable input.
7 Make sure that the following items are connected and installed on your HP Digital Entertainment Center:
AC power source Keyboard (Pull the battery tab.) Audio Out
TV source Remote control (Insert the Batteries.) Video Out
Internet connection
8 Turn on the HP Digital Entertainment Center for the first time by pressing the On/Standby power button.
After you first turn on your system
1 Wait for the Windows
®
Welcome screen to appear. Click Next to set up your system. Do not turn off
your system.
NOTE: The screen may flash on occasion. This occurs only during setup or setting changes and does not affect
performance.
2 Complete the initial Windows
®
setup wizard. Use the keyboard and follow the onscreen instructions. You hear
music if the audio is connected. Click Finish.
3 After a countdown and a blank screen, Windows restarts automatically. Do not turn off your system
during this one time process.
4 After the HP Digital Entertainment Center restarts, use the TV/Display Setup Wizard to optimize your
TV/Display. Follow the onscreen instructions. See “TV/Display Setup Wizard” on page 5.
5 Complete the Required Media Center setup wizard. Follow the onscreen instructions and answer any questions
as required, to set up Internet and network connections.
6 Complete the Optional Media Center setup wizard. Follow the onscreen instructions. (You may skip sections
that do not apply to your setup and change the settings at a later time using Media Center.)
Configure tuners, TV signal, and Television Program Guide information.
Select and adjust Media Center display settings.
Set up speakers.
Teach the HP Digital Entertainment Center to control your cable TV or satellite receiver set-top box.
7 Refer to the User’s Guide to complete the audio settings. Use this guide for the video settings.
Begin using your HP Digital Entertainment Center.
NOTE: See “Adjusting Video” on page 4 and run the TV/Display Setup Wizard again if the picture is not
satisfactory after you have completed the setup procedure. See “Video Troubleshooting” on page 15 if you can’t
see a picture.