Filter
Top Products
Timer Recording
30
Weekly Recording
1 With the Rec-On day flashing, press the 5 key.
2 Press the number for the day. For Sunday, press the 1 key, for
Monday, the 2 key, for Tuesday, the 3 key and so on.
After a Timer Recording Has Taken Place:
Press the Timer button off on the remote control to return your TV/VCR
Combination to normal operation.
While you can use the OTR along with timer recording, be sure to check
your recording times carefully. Timer recording is preempted during either
OTR or Standby OTR recording. When you want a timer recording to be
done, be sure to press the Timer button on after a tape rewind, playback,
or other operation, or after you set a Standby OTR.
If the record tab is missing, the tape will be ejected.
If the cassette tape is not inserted, the Timer indicator will flash.
To Check or Re-Enter Timer Programs
When a timer Recording has been set, but is not yet in Progress. (Timer
indicator is on.)
1 Press the Timer button off to release the timer set mode.
2 Follow steps 1 to 3 on page 19. In step 3, check the program contents
for each program number. Make corrections and continue with steps 4 to
9.
3 After you are sure that the programs in step 9 are set correctly, press
the Prog button three times to return to watching TV.
4 Press the Timer Button on to set the timer mode on.
When re-entering timer programs, you may skip over correct information
and go directly to an item you wish to change by using the Channel Up
key.
To change from the "L" recording mode, the Input button must be pressed.
A tuner channel can now be entered.
When Timer Recording is in Progress.
Press the Prog button on the remote control. The screen below will
appear.
All currently set programs will be shown. The program in progress will be
flashing. All programs can be checked at this stage. The display will
disappear after about 30 seconds. To immediately return to the program